C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv4
– 1262 –
DEFAULT SETTING
125 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the general query interval at which active receiver
ports send out general queries. This interval is only effective when proxy
switching is enabled with the mvr proxy-switching command.
EXAMPLE
This example sets the proxy query interval for MVR proxy switching.
Console(config)#mvr proxy-query-interval 250
Console(config)#
mvr priority This command assigns a priority to all multicast traffic in the MVR VLAN.
Use the no form of this command to restore the default setting.
SYNTAX
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded
into the MVR VLAN. (Range: 0-7, where 7 is the highest priority)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
This command can be used to set a high priority for low-latency multicast
traffic such as a video-conference, or to set a low priority for normal
multicast traffic not sensitive to latency.
EXAMPLE
Console(config)#mvr priority 6
Console(config)#
RELATED COMMANDS
show mvr
To Next Page
Loading...
Need help?
General
