C
HAPTER
20
| System Management Commands
Banner Information
– 701 –
banner configure This command is used to interactively specify administrative information
for this device.
SYNTAX
banner configure
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
The administrator can batch-input all details for the switch with one
command. When the administrator finishes typing the company name and
presses the enter key, the script prompts for the next piece of information,
and so on, until all information has been entered. Pressing enter without
inputting information at any prompt during the script’s operation will leave
the field empty. Spaces can be used during script mode because pressing
the enter key signifies the end of data input. The delete and left-arrow keys
terminate the script. The use of the backspace key during script mode is
not supported. If, for example, a mistake is made in the company name, it
can be corrected with the banner configure company command.
EXAMPLE
Console(config)#banner configure
Company: Edge-Core Networks
Responsible department: R&D Dept
Name and telephone to Contact the management people
Manager1 name: Sr. Network Admin
phone number: 123-555-1212
Manager2 name: Jr. Network Admin
phone number: 123-555-1213
Manager3 name: Night-shift Net Admin / Janitor
phone number: 123-555-1214
The physical location of the equipment.
City and street address: 12 Straight St. Motown, Zimbabwe
Information about this equipment:
Manufacturer: Edge-Core Networks
ID: 123_unique_id_number
Floor: 2
banner configure
manager-info
Configures the Manager contact information that is
displayed by banner
GC
banner configure mux Configures the MUX information that is displayed by
banner
GC
banner configure note Configures miscellaneous information that is displayed
by banner under the Notes heading
GC
show banner Displays all banner information NE, PE
Table 48: Banner Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
