C
HAPTER
20
| System Management Commands
Time Range
– 762 –
COMMAND MODE
Privileged Exec
COMMAND USAGE
Note that when SNTP is enabled, the system clock cannot be manually
configured.
EXAMPLE
This example shows how to set the system clock to 15:12:34, February
1st, 2011.
Console#calendar set 15:12:34 1 February 2011
Console#
show calendar This command displays the system clock.
DEFAULT SETTING
None
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show calendar
Current Time : Aug 23 11:51:23 2012
Time Zone : UTC, 00:00
Summer Time : MESZ, Australia region
Summer Time in Effect : No
Console#
TIME RANGE
This section describes the commands used to sets a time range for use by
other functions, such as Access Control Lists.
Table 61: Time Range Commands
Command Function Mode
time-range Specifies the name of a time range, and enters time
range configuration mode
GC
absolute Sets the time range for the execution of a command TR
periodic Sets the time range for the periodic execution of a
command
TR
show time-range Shows configured time ranges. PE
To Next Page
Loading...
Need help?
General
