Edge-Core ES3528MV2

C HAPTER 41 | CFM Commands
Link Trace Operations
– 1348 –
show ethernet cfm
maintenance-points
remote crosscheck
This command displays information about remote MEPs statically
configured in a cross-check list.
SYNTAX
show ethernet cfm maintenance-points remote crosscheck
[domain domain-name | mpid mpid]
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
mpid – Maintenance end point identifier. (Range: 1-8191)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
This example shows all remote MEPs statically configured on this device.
Console#show ethernet cfm maintenance-points remote crosscheck
MPID MA Name Level VLAN MEP Up Remote MAC
---- -------------------- ----- ---- ------ ------------------
2 downtown 4 2 Yes 00-0D-54-FC-A2-73
Console#
Link Trace Operations
ethernet cfm
linktrace cache
This command enables caching of CFM data learned through link trace
messages. Use the no form to disable caching.
SYNTAX
[no] ethernet cfm linktrace cache
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ A link trace message is a multicast CFM frame initiated by a MEP, and
forwarded from MIP to MIP, with each MIP generating a link trace reply,
up to the point at which the link trace message reaches its destination
or can no longer be forwarded.
◆ Use this command to enable the link trace cache to store the results of
link trace operations initiated on this device. Use the ethernet cfm
linktrace command to transmit a link trace message.