Edge-Core ES3528MV2 - Show Snmp-Server Enable Port-Traps; Snmp-Server Engine-ID; Snmpv3 Commands

C HAPTER 21 | SNMP Commands
SNMPv3 Commands
– 782 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps mac-notification
Console(config)#
show snmp-server
enable port-traps
This command shows if SNMP traps are enabled or disabled for the
specified interfaces.
SYNTAX
show snmp-server enable port-traps interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-8)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show snmp-server enable port-traps interface
Interface MAC Notification Trap
--------- ---------------------
Eth 1/1 No
Eth 1/2 No
Eth 1/3 No
.
.
.
SNMPv3 Commands
snmp-server
engine-id
This command configures an identification string for the SNMPv3 engine.
Use the no form to restore the default.
SYNTAX
snmp-server engine-id {local | remote {ip-address}}
engineid-string
no snmp-server engine-id {local | remote {ip-address}}
local - Specifies the SNMP engine on this switch.
remote - Specifies an SNMP engine on a remote device.
ip-address - The Internet address of the remote device.
engineid-string - String identifying the engine ID. (Range: 1-26
hexadecimal characters)