C
HAPTER
15
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 581 –
WEB INTERFACE
To show neighboring IPv6 devices:
1. Click IP, IPv6 Configuration.
2. Select Show IPv6 Neighbors from the Action list.
Figure 338: Showing IPv6 Neighbors
SHOWING IPV6
S
TATISTICS
Use the IP > IPv6 Configuration (Show Statistics) page to display statistics
about IPv6 traffic passing through this switch.
CLI REFERENCES
◆ "show ipv6 traffic" on page 1417
COMMAND USAGE
This switch provides statistics for the following traffic types:
◆ IPv6 – The Internet Protocol for Version 6 addresses provides a
mechanism for transmitting blocks of data (often called packets or
frames) from a source to a destination, where these network devices
(that is, hosts) are identified by fixed length addresses. The Internet
Protocol also provides for fragmentation and reassembly of long
packets, if necessary, for transmission through “small packet”
networks.
State
(continued)
◆
Delay - More than the ReachableTime interval has elapsed since the
last positive confirmation was received that the forward path was
functioning. A packet was sent within the last
DELAY_FIRST_PROBE_TIME interval. If no reachability confirmation is
received within this interval after entering the DELAY state, the switch
will send a neighbor solicitation message and change the state to
PROBE.
◆
Probe - A reachability confirmation is actively sought by resending
neighbor solicitation messages every RetransTimer interval until
confirmation of reachability is received.
The following states are used for static entries:
◆
Incomplete -The interface for this entry is down.
◆
Reachable - The interface for this entry is up. Reachability detection is
not applied to static entries in the IPv6 neighbor discovery cache.
VLAN VLAN interface from which the address was reached.
Table 38: Show IPv6 Neighbors - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General
