C
HAPTER
20
| System Management Commands
Banner Information
– 707 –
banner configure
manager-info
This command is used to configure the manager contact information
displayed in the banner. Use the no form to restore the default setting.
SYNTAX
banner configure manager-info
name mgr1-name phone-number mgr1-number
[name2 mgr2-name phone-number mgr2-number |
name3 mgr3-name phone-number mgr3-number]
no banner configure manager-info [name1 | name2 | name3]
mgr1-name - The name of the first manager.
mgr1-number - The phone number of the first manager.
mgr2-name - The name of the second manager.
mgr2-number - The phone number of the second manager.
mgr3-name - The name of the third manager.
mgr3-number - The phone number of the third manager.
Maximum length of each parameter: 32 characters
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
Input strings cannot contain spaces. The banner configure manager-
info command interprets spaces as data input boundaries. The use of
underscores ( _ ) or other unobtrusive non-letter characters is suggested
for situations where white space is necessary for clarity.
EXAMPLE
Console(config)#banner configure manager-info name Albert_Einstein phone-
number 123-555-1212 name2 Lamar phone-number 123-555-1219
Console(config)#
banner configure
mux
This command is used to configure the mux information displayed in the
banner. Use the no form to restore the default setting.
SYNTAX
banner configure mux muxinfo
no banner configure mux
muxinfo - The circuit and PVC to which the switch is connected.
(Maximum length: 32 characters)
To Next Page
Loading...
Need help?
General
