C
HAPTER
31
| Loopback Detection Commands
– 1050 –
EXAMPLE
Console(config)#loopback-detection recover-time 120
Console(config-if)#
loopback-detection
transmit-interval
This command specifies the interval at which to transmit loopback
detection control frames. Use the no form to restore the default setting.
SYNTAX
loopback-detection transmit-interval
seconds
no
loopback-detection transmit-interval
seconds
- The transmission interval for loopback detection control
frames. (Range: 1-32767 seconds)
DEFAULT SETTING
10 seconds
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#loopback-detection transmit-interval 60
Console(config)#
loopback detection
trap
This command sends a trap when a loopback condition is detected, or when
the switch recovers from a loopback condition. Use the no form to restore
the default state.
SYNTAX
loopback-detection trap
[
both
|
detect
|
none
|
recover
]
no
loopback-detection trap
both
- Sends an SNMP trap message when a loopback condition is
detected, or when the switch recovers from a loopback condition.
detect
- Sends an SNMP trap message when a loopback condition is
detected.
none
- Does not send an SNMP trap for loopback detection or
recovery.
recover
- Sends an SNMP trap message when the switch recovers
from a loopback condition.
DEFAULT SETTING
None
To Next Page
Loading...
