– 49 –
FIGURES
Figure 1: Home Page 98
Figure 2: Front Panel Indicators 99
Figure 3: System Information 118
Figure 4: General Switch Information 119
Figure 5: Configuring Support for Jumbo Frames 120
Figure 6: Displaying Bridge Extension Configuration 122
Figure 7: Copy Firmware 124
Figure 8: Saving the Running Configuration 125
Figure 9: Setting Start-Up Files 126
Figure 10: Displaying System Files 126
Figure 11: Configuring Automatic Code Upgrade 130
Figure 12: Manually Setting the System Clock 132
Figure 13: Setting the Polling Interval for SNTP 133
Figure 14: Configuring NTP 134
Figure 15: Specifying SNTP Time Servers 135
Figure 16: Adding an NTP Time Server 136
Figure 17: Showing the NTP Time Server List 136
Figure 18: Adding an NTP Authentication Key 137
Figure 19: Showing the NTP Authentication Key List 137
Figure 20: Setting the Time Zone 138
Figure 21: Console Port Settings 140
Figure 22: Telnet Connection Settings 142
Figure 23: Displaying CPU Utilization 143
Figure 24: Displaying Memory Utilization 143
Figure 25: Restarting the Switch (Immediately) 146
Figure 26: Restarting the Switch (In) 146
Figure 27: Restarting the Switch (At) 147
Figure 28: Restarting the Switch (Regularly) 147
Figure 29: Configuring Connections by Port List 152
Figure 30: Configuring Connections by Port Range 153
Figure 31: Displaying Port Information 154
To Next Page
Loading...
Need help?
General
