Edge-Core ES3528MV2

C HAPTER 39 | Multicast Filtering Commands
MVR for IPv4
– 1264 –
RELATED COMMANDS
mvr robustness-value (1264)
mvr
robustness-value
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
SYNTAX
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command is used to set the number of times report messages are
sent upstream when changes are learned about downstream groups,
and the number of times group-specific queries are sent to downstream
receiver ports.
◆ This command only takes effect when MVR proxy switching is enabled.
EXAMPLE
Console(config)#mvr robustness-value 5
Console(config)#
RELATED COMMANDS
mvr proxy-switching (1263)
mvr
source-port-mode
dynamic
This command configures the switch to only forward multicast streams
which the source port has dynamcially joined. Use the no form to restore
the default setting.
SYNTAX
[no] mvr source-port-mode dynamic
DEFAULT SETTING
Forwards all multicast streams which have been specified in a profile and
bound to a domain.
COMMAND MODE
Global Configuration