C
HAPTER
20
| System Management Commands
Time
– 761 –
hours - Number of hours before/after UTC. (Range: 0-12 hours
before UTC, 0-13 hours after UTC)
minutes - Number of minutes before/after UTC. (Range: 0-59
minutes)
before-utc - Sets the local time zone before (east) of UTC.
after-utc - Sets the local time zone after (west) of UTC.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth’s prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC.
EXAMPLE
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
RELATED COMMANDS
show sntp (752)
calendar set This command sets the system clock. It may be used if there is no time
server on your network, or if you have not configured the switch to receive
signals from a time server.
SYNTAX
calendar set hour min sec {day month year | month day year}
hour - Hour in 24-hour format. (Range: 0 - 23)
min - Minute. (Range: 0 - 59)
sec - Second. (Range: 0 - 59)
day - Day of month. (Range: 1 - 31)
month - january | february | march | april | may | june | july |
august | september | october | november | december
year - Year (4-digit). (Range: 1970 - 2037)
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General
