C
HAPTER
40
| LLDP Commands
– 1302 –
enterprise specific or other starting points for the search, such as the
Interface or Entity MIB.
â—† Since there are typically a number of different addresses associated
with a Layer 3 device, an individual LLDP PDU may contain more than
one management address TLV.
â—† Every management address TLV that reports an address that is
accessible on a port and protocol VLAN through the particular port
should be accompanied by a port and protocol VLAN TLV that indicates
the VLAN identifier (VID) associated with the management address
reported by this TLV.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#
lldp basic-tlv
port-description
This command configures an LLDP-enabled port to advertise its port
description. Use the no form to disable this feature.
SYNTAX
[no] lldp basic-tlv port-description
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
The port description is taken from the ifDescr object in RFC 2863, which
includes information about the manufacturer, the product name, and the
version of the interface hardware/software.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv port-description
Console(config-if)#
To Next Page
Loading...
Need help?
General
