Edge-Core ES3528MV2 - Show Gvrp Configuration

C HAPTER 36 | VLAN Commands
GVRP and Bridge Extension Commands
– 1130 –
port-channel channel-id (Range: 1-12)
DEFAULT SETTING
Shows all GARP timers.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP Timer Status:
Join Timer : 20 centiseconds
Leave Timer : 60 centiseconds
Leave All Timer : 1000 centiseconds
Console#
RELATED COMMANDS
garp timer (1127)
show gvrp
configuration
This command shows if GVRP is enabled.
SYNTAX
show gvrp configuration [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-12)
DEFAULT SETTING
Shows both global and interface-specific configuration.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
GVRP Configuration : Disabled
Console#