Edge-Core ES3528MV2 - Show Power-Save

C HAPTER 27 | Interface Commands
Power Savings
– 1001 –
N OTE : Power savings can only be implemented on Gigabit Ethernet ports
using twisted-pair cabling. Power-savings mode on a active link only works
when connection speed is 1 Gbps, and line length is less than 60 meters.
EXAMPLE
Console(config)#interface ethernet 1/28
Console(config-if)#power-save
Console(config-if)#
show power-save This command shows the configuration settings for power savings.
SYNTAX
show power-save [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show power-save interface ethernet 1/28
Power Saving Status:
Ethernet 1/28 : Enabled
Console#