Edge-Core ES3528MV2 - Show Ethernet Cfm Configuration

C HAPTER 41 | CFM Commands
Defining CFM Structures
– 1332 –
show ethernet cfm
configuration
This command displays CFM configuration settings, including global
settings, SNMP traps, and interface settings.
SYNTAX
show ethernet cfm configuration {global | traps |
interface interface}
global – Displays global settings including CFM global status, cross-
check start delay, and link trace parameters.
traps – Displays the status of all continuity check and cross-check
traps.
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-12)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
This example shows the global settings for CFM.
Console#show ethernet cfm configuration global
CFM Global Status : Enabled
Crosscheck Start Delay : 10 seconds
Linktrace Cache Status : Enabled
Linktrace Cache Hold Time : 100 minutes
Linktrace Cache Size : 100 entries
Console#
This example shows the configuration status for continuity check and
cross-check traps.
Console#show ethernet cfm configuration traps
CC MEP Up Trap :Disabled
CC MEP Down Trap :Disabled
CC Configure Trap :Disabled
CC Loop Trap :Disabled
Cross Check MEP Unknown Trap :Disabled
Cross Check MEP Missing Trap :Disabled
Cross Check MA Up :Disabled
Console#