C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv4
– 1272 –
show mvr interface This command shows MVR configuration settings for interfaces attached to
the MVR VLAN.
SYNTAX
show mvr [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Displays configuration settings for all attached interfaces.
COMMAND MODE
Privileged Exec
EXAMPLE
The following displays information about the interfaces attached to the
MVR VLAN in domain 1:
Console#show mvr domain 1 interface
MVR Domain : 1
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- --------------------
Eth 1/ 1 Source Active/Forwarding
Eth 1/ 2 Receiver Inactive/Discarding Disabled 234.5.6.8(VLAN2)
Eth1/ 3 Source Inactive/Discarding
Eth1/ 1 Receiver Active/Forwarding Disabled 225.0.0.1(VLAN1)
225.0.0.9(VLAN3)
Eth1/ 4 Receiver Active/Discarding Disabled
Console#
Table 164: show mvr interface - display description
Field Description
MVR Domain An independent multicast domain.
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR
status for receiver ports is “ACTIVE” only if there are subscribers
receiving multicast traffic from one of the MVR groups, or a
multicast group has been statically assigned to an interface. Also
shows if MVR traffic is being forwarded or discarded.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the
receiver VLAN.
To Next Page
Loading...
Need help?
General
