C
HAPTER
24
| Authentication Commands
Secure Shell
– 838 –
ip telnet server This command allows this device to be monitored or configured from
Telnet. Use the no form to disable this function.
SYNTAX
[no] ip telnet server
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#ip telnet server
Console(config)#
show ip telnet This command displays the configuration settings for the Telnet server.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show ip telnet
IP Telnet Configuration:
Telnet Status: Enabled
Telnet Service Port: 23
Telnet Max Session: 4
Console#
SECURE SHELL
This section describes the commands used to configure the SSH server.
Note that you also need to install a SSH client on the management station
when using this protocol to configure the switch.
N
OTE
:
The switch supports both SSH Version 1.5 and 2.0 clients.
Table 80: Secure Shell Commands
Command Function Mode
ip ssh authentication-
retries
Specifies the number of retries allowed by a client GC
ip ssh server Enables the SSH server on the switch GC
ip ssh server key size Sets the SSH server key size GC
To Next Page
Loading...
Need help?
General
