Edge-Core ES3528MV2 - Show Line

C HAPTER 20 | System Management Commands
Line
– 738 –
length - The number of lines displayed on the screen.
(Range: 0-512, where 0 means not to pause)
terminal-type - The type of terminal emulation used.
ansi-bbs - ANSI-BBS
vt-100 - VT-100
vt-102 - VT-102
width - The number of character columns displayed on the
terminal. (Range: 0-80)
DEFAULT SETTING
Escape Character: 27 (ASCII-number)
History: 10
Length: 24
Terminal Type: VT100
Width: 80
COMMAND MODE
Privileged Exec
EXAMPLE
This example sets the number of lines displayed by commands with lengthy
output such as show running-config to 48 lines.
Console#terminal length 48
Console#
show line This command displays the terminal line’s parameters.
SYNTAX
show line [console | vty]
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
DEFAULT SETTING
Shows all lines
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
To show all lines, enter this command:
Console#show line
Terminal Configuration for this session:
Length : 24
Width : 80