C
HAPTER
40
| LLDP Commands
– 1304 –
lldp basic-tlv
system-name
This command configures an LLDP-enabled port to advertise the system
name. Use the no form to disable this feature.
SYNTAX
[no] lldp basic-tlv system-name
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
The system name is taken from the sysName object in RFC 3418, which
contains the system’s administratively assigned name, and is in turn based
on the hostname command.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv system-name
Console(config-if)#
lldp dot1-tlv
proto-ident
This command configures an LLDP-enabled port to advertise the supported
protocols. Use the no form to disable this feature.
SYNTAX
[no] lldp dot1-tlv proto-ident
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises the protocols that are accessible through this
interface.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-ident
Console(config-if)#
To Next Page
Loading...
Need help?
General
