C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv6
– 1285 –
mvr6
immediate-leave
This command causes the switch to immediately remove an interface from
a multicast stream as soon as it receives a leave message for that group.
Use the no form to restore the default settings.
SYNTAX
[no] mvr6 domain domain-id immediate-leave
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
â—† Immediate leave applies only to receiver ports. When enabled, the
receiver port is immediately removed from the multicast group
identified in the leave message. When immediate leave is disabled, the
switch follows the standard rules by sending a group-specific query to
the receiver port and waiting for a response to determine if there are
any remaining subscribers for that multicast group before removing the
port from the group list.
â—† Using immediate leave can speed up leave latency, but should only be
enabled on a port attached to only one multicast subscriber to avoid
disrupting services to other group members attached to the same
interface.
â—† Immediate leave does not apply to multicast groups which have been
statically assigned to a port with the mvr6 vlan group command.
EXAMPLE
The following enables immediate leave on a receiver port.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr6 domain 1 immediate-leave
Console(config-if)#
mvr6 type This command configures an interface as an MVR receiver or source port.
Use the no form to restore the default settings.
SYNTAX
[no] mvr6 domain domain-id type {receiver | source}
domain-id - An independent multicast domain. (Range: 1-5)
receiver - Configures the interface as a subscriber port that can
receive multicast data.
To Next Page
Loading...
Need help?
General
