Edge-Core ES3528MV2

C HAPTER 39 | Multicast Filtering Commands
MVR for IPv6
– 1282 –
■
When a receiver port receives a query message, it will be dropped.
EXAMPLE
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
RELATED COMMANDS
mvr6 robustness-value (1282)
mvr6
robustness-value
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
SYNTAX
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command sets the number of times report messages are sent
upstream when changes are learned about downstream groups, and
the number of times group-specific queries are sent to downstream
receiver ports.
◆ This command only takes effect when MVR6 proxy switching is enabled.
EXAMPLE
Console(config)#mvr6 robustness-value 5
Console(config)#
RELATED COMMANDS
mvr6 proxy-switching (1281)