C
HAPTER
16
| IP Services
Domain Name Service
– 593 –
Figure 347: Showing the List of Name Servers for DNS
CONFIGURING
STATIC DNS HOST
TO ADDRESS ENTRIES
Use the IP Service > DNS - Static Host Table (Add) page to manually
configure static entries in the DNS table that are used to map domain
names to IP addresses.
CLI REFERENCES
â—† "ip host" on page 1376
â—† "show hosts" on page 1380
COMMAND USAGE
Static entries may be used for local devices connected directly to the
attached network, or for commonly used resources located elsewhere on
the network.
PARAMETERS
These parameters are displayed:
◆ Host Name – Name of a host device that is mapped to one or more IP
addresses. (Range: 1-127 characters)
◆ IP Address – Internet address(es) associated with a host name.
WEB INTERFACE
To configure static entries in the DNS table:
1. Click IP Service, DNS, Static Host Table.
2. Select Add from the Action list.
3. Enter a host name and the corresponding address.
4. Click Apply.
To Next Page
Loading...
Need help?
General
