C
HAPTER
15
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 580 –
WEB INTERFACE
To show the configured IPv6 addresses:
1. Click IP, IPv6 Configuration.
2. Select Show IPv6 Address from the Action list.
3. Select a VLAN from the list.
Figure 337: Showing Configured IPv6 Addresses
SHOWING THE IPV6
NEIGHBOR CACHE
Use the IP > IPv6 Configuration (Show IPv6 Neighbor Cache) page to
display the IPv6 addresses detected for neighbor devices.
CLI REFERENCES
◆ "show ipv6 neighbors" on page 1429
PARAMETERS
These parameters are displayed:
Table 38: Show IPv6 Neighbors - display description
Field Description
IPv6 Address IPv6 address of neighbor
Age The time since the address was verified as reachable (in seconds). A static
entry is indicated by the value “Permanent.”
Link-layer Addr Physical layer MAC address.
State The following states are used for dynamic entries:
◆
Incomplete - Address resolution is being carried out on the entry.
A neighbor solicitation message has been sent to the multicast
address of the target, but it has not yet returned a neighbor
advertisement message.
◆
Invalid - An invalidated mapping. Setting the state to invalid dis-
associates the interface identified with this entry from the indicated
mapping (RFC 4293).
◆
Reachable - Positive confirmation was received within the last
ReachableTime interval that the forward path to the neighbor was
functioning. While in REACH state, the device takes no special action
when sending packets.
◆
Stale - More than the ReachableTime interval has elapsed since the
last positive confirmation was received that the forward path was
functioning. While in STALE state, the device takes no action until a
packet is sent.
To Next Page
Loading...
Need help?
General
