C
HAPTER
16
| IP Services
Domain Name Service
– 590 –
PARAMETERS
These parameters are displayed:
◆ Domain Lookup – Enables DNS host name-to-address translation.
(Default: Disabled)
◆ Default Domain Name – Defines the default domain name appended
to incomplete host names. Do not include the initial dot that separates
the host name from the domain name. (Range: 1-127 alphanumeric
characters)
WEB INTERFACE
To configure general settings for DNS:
1. Click IP Service, DNS.
2. Select Configure Global from the Action list.
3. Enable domain lookup, and set the default domain name.
4. Click Apply.
Figure 343: Configuring General Settings for DNS
CONFIGURING A LIST
OF DOMAIN NAMES
Use the IP Service > DNS - General (Add Domain Name) page to configure
a list of domain names to be tried in sequential order.
CLI REFERENCES
â—† "ip domain-list" on page 1373
â—† "show dns" on page 1379
COMMAND USAGE
â—† Use this page to define a list of domain names that can be appended to
incomplete host names (i.e., host names passed from a client that are
not formatted with dotted notation).
â—† If there is no domain list, the default domain name is used (see
"Configuring General DNS Service Parameters" on page 589). If there is
a domain list, the system will search it for a corresponding entry. If
none is found, it will use the default domain name.
â—† When an incomplete host name is received by the DNS service on this
switch and a domain name list has been specified, the switch will work
To Next Page
Loading...
Need help?
General
