C
HAPTER
20
| System Management Commands
Switch Clustering
– 769 –
cluster member This command configures a Candidate switch as a cluster Member. Use the
no form to remove a Member switch from the cluster.
SYNTAX
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
DEFAULT SETTING
No Members
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† The maximum number of cluster Members is 36.
â—† The maximum number of cluster Candidates is 100.
EXAMPLE
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
SYNTAX
rcommand id member-id
member-id - The ID number of the Member switch.
(Range: 1-36)
COMMAND MODE
Privileged Exec
COMMAND USAGE
â—† This command only operates through a Telnet connection to the
Commander switch. Managing cluster Members using the local console
CLI on the Commander is not supported.
â—† There is no need to enter the username and password for access to the
Member switch CLI.
To Next Page
Loading...
Need help?
General
