C
HAPTER
20
| System Management Commands
File Management
– 727 –
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command is used in conjunction with the upgrade opcode auto
command to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
◆ The name for the new image stored on the TFTP server must be
es3528mv2.bix. However, note that file name is not to be included in
this command.
◆ When specifying a TFTP server, the following syntax must be used,
where filedir indicates the path to the directory containing the new
image:
tftp://192.168.0.1[/filedir]/
◆ When specifying an FTP server, the following syntax must be used,
where filedir indicates the path to the directory containing the new
image:
ftp://[username[:password@]]192.168.0.1[/filedir]/
If the user name is omitted, “anonymous” will be used for the
connection. If the password is omitted a null string (“”) will be used for
the connection.
EXAMPLE
This shows how to specify a TFTP server where new code is stored.
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
This shows how to specify an FTP server where new code is stored.
Console(config)#upgrade opcode path ftp://admin:billy@192.168.0.1/sm24/
Console(config)#
upgrade opcode
reload
This command reloads the switch automatically after the opcode upgrade is
completed. Use the no form to disable this feature.
SYNTAX
[no] upgrade opcode reload
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
To Next Page
Loading...
Need help?
General
