C
HAPTER
13
| Security Measures
Network Access (MAC Address Authentication)
– 332 –
port remains unaffected. (Range: 120-1000000 seconds;
Default: 1800 seconds)
WEB INTERFACE
To configure aging status and reauthentication time for MAC address
authentication:
1. Click Security, Network Access.
2. Select Configure Global from the Step list.
3. Enable or disable aging for secure addresses, and modify the
reauthentication time as required.
4. Click Apply.
Figure 175: Configuring Global Settings for Network Access
CONFIGURING
NETWORK ACCESS
FOR PORTS
Use the Security > Network Access (Configure Interface - General) page to
configure MAC authentication on switch ports, including enabling address
authentication, setting the maximum MAC count, and enabling dynamic
VLAN or dynamic QoS assignments.
CLI REFERENCES
â—† "Network Access (MAC Address Authentication)" on page 879
PARAMETERS
These parameters are displayed:
â—† MAC Authentication
â–
Status – Enables MAC authentication on a port. (Default: Disabled)
â–
Intrusion – Sets the port response to a host MAC authentication
failure to either block access to the port or to pass traffic through.
(Options: Block, Pass; Default: Block)
â–
Max MAC Count
5
– Sets the maximum number of MAC addresses
that can be authenticated on a port via MAC authentication; that is,
5. The maximum number of MAC addresses per port is 1024, and the maximum number of
secure MAC addresses supported for the switch system is 1024. When the limit is
reached, all new MAC addresses are treated as authentication failures.
To Next Page
Loading...
Need help?
General
