C
HAPTER
36
| VLAN Commands
Editing VLAN Groups
– 1131 –
EDITING VLAN GROUPS
vlan database This command enters VLAN database mode. All commands in this mode
will take effect immediately.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the VLAN
settings by entering the show vlan command.
â—† Use the interface vlan command mode to define the port membership
mode and add or remove ports from a VLAN. The results of these
commands are written to the running-configuration file, and you can
display this file by entering the show running-config command.
EXAMPLE
Console(config)#vlan database
Console(config-vlan)#
RELATED COMMANDS
show vlan (1139)
Table 135: Commands for Editing VLAN Groups
Command Function Mode
vlan database Enters VLAN database mode to add, change, and
delete VLANs
GC
vlan Configures a VLAN, including VID, name and state VC
To Next Page
Loading...
Need help?
General
