C
HAPTER
33
| Address Table Commands
– 1062 –
COMMAND USAGE
◆ The MAC Address Table contains the MAC addresses associated with
each interface. Note that the Type field may include the following types:
■
Learn - Dynamic address entries
■
Learned-PSEC - Address learned through port security
■
Config - Static entry
◆ The mask should be hexadecimal numbers (representing an equivalent
bit mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified
MAC address. Enter hexadecimal numbers, where an equivalent binary
bit “0” means to match a bit and “1” means to ignore a bit. For
example, a mask of 00-00-00-00-00-00 means an exact match, and a
mask of FF-FF-FF-FF-FF-FF means “any.”
◆ The maximum number of address entries is 16K.
EXAMPLE
Console#show mac-address-table
Total entry in system: 3
Interface MAC Address VLAN Type Life Time
--------- ----------------- ---- -------- -----------------
CPU 00-E0-00-00-00-01 1 CPU Delete on Reset
Eth 1/ 1 00-E0-0C-10-90-09 1 Learn Delete on Timeout
Eth 1/ 1 00-E0-29-94-34-64 1 Learn Delete on Timeout
Console#
show mac-address-
table aging-time
This command shows the aging time for entries in the address table.
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show mac-address-table aging-time
Aging Status : Enabled
Aging Time: 300 sec.
Console#
To Next Page
Loading...
