C
HAPTER
30
| Congestion Control Commands
Automatic Traffic Control Commands
– 1034 –
Threshold Commands
auto-traffic-control
apply-timer
This command sets the time at which to apply the control response after
ingress traffic has exceeded the upper threshold. Use the no form to
restore the default setting.
SYNTAX
auto-traffic-control {broadcast | multicast} apply-timer seconds
no auto-traffic-control {broadcast | multicast} apply-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The interval after the upper threshold has been exceeded
at which to apply the control response. (Range: 1-300 seconds)
DEFAULT SETTING
300 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
After the apply timer expires, a control action may be triggered as specified
by the auto-traffic-control action command and a trap message sent as
specified by the snmp-server enable port-traps atc broadcast-control-apply
command or snmp-server enable port-traps atc multicast-control-apply
command.
EXAMPLE
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
auto-traffic-control
release-timer
This command sets the time at which to release the control response after
ingress traffic has fallen beneath the lower threshold. Use the no form to
restore the default setting.
SYNTAX
auto-traffic-control {broadcast | multicast} release-timer
seconds
no auto-traffic-control {broadcast | multicast} release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
To Next Page
Loading...
Need help?
General
