C
HAPTER
24
| Authentication Commands
RADIUS Client
– 816 –
RADIUS CLIENT
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access to RADIUS-aware devices on the network. An authentication
server contains a database of multiple user name/password pairs with
associated privilege levels for each user or group that require management
access to a switch.
radius-server
acct-port
This command sets the RADIUS server network port for accounting
messages. Use the no form to restore the default.
SYNTAX
radius-server acct-port port-number
no radius-server acct-port
port-number - RADIUS server UDP port used for accounting
messages. (Range: 1-65535)
DEFAULT SETTING
1813
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#radius-server acct-port 181
Console(config)#
Table 74: RADIUS Client Commands
Command Function Mode
radius-server acct-port Sets the RADIUS server network port GC
radius-server auth-port Sets the RADIUS server network port GC
radius-server host Specifies the RADIUS server GC
radius-server key Sets the RADIUS encryption key GC
radius-server retransmit Sets the number of retries GC
radius-server timeout Sets the interval between sending authentication
requests
GC
show radius-server Shows the current RADIUS settings PE
To Next Page
Loading...
