Edge-Core ES3528MV2 - Snmp-Server Enable Port-Traps Atc Multicast-Alarm-Clear

C HAPTER 30 | Congestion Control Commands
Automatic Traffic Control Commands
– 1042 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-
release
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-clear-threshold (1037)
auto-traffic-control action (1036)
auto-traffic-control release-timer (1034)
snmp-server enable
port-traps atc
multicast-alarm-
clear
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc multicast-alarm-clear
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-clear
Console(config-if)#
RELATED COMMANDS
auto-traffic-control action (1036)
auto-traffic-control alarm-clear-threshold (1037)
snmp-server enable
port-traps atc
multicast-alarm-fire
This command sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control. Use the no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc multicast-alarm-fire
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)