– 149 –
5 INTERFACE CONFIGURATION
This chapter describes the following topics:
◆ Port Configuration – Configures connection settings, including auto-
negotiation, or manual setting of speed, duplex mode, and flow control.
◆ Local Port Mirroring – Sets the source and target ports for mirroring on
the local switch.
◆ Remote Port Mirroring – Configures mirroring of traffic from remote
switches for analysis at a destination port on the local switch.
◆ Displaying Statistics – Shows Interface, Etherlike, and RMON port
statistics in table or chart form.
◆ Displaying Transceiver Data – Displays identifying information, and
operational parameters for optical transceivers which support DDM.
◆ Configuring Transceiver Thresholds – Configures thresholds for alarm
and warning messages for optical transceivers which support DDM.
◆ Cable Test – Performs cable diagnostics on the specified port.
◆ Trunk Configuration – Configures static or dynamic trunks.
◆ Saving Power – Adjusts the power provided to ports based on the
length of the cable used to connect to other devices.
◆ Traffic Segmentation – Configures the uplinks and down links to a
segmented group of ports.
◆ VLAN Trunking – Configures a tunnel across one or more intermediate
switches which pass traffic for VLAN groups to which they do not
belong.
To Next Page
Loading...
