C
HAPTER
41
| CFM Commands
Fault Generator Operations
– 1357 –
show ethernet cfm
fault-notify-
generator
This command displays configuration settings for the fault notification
generator.
SYNTAX
show ethernet cfm fault-notify-generator mep mpid
mpid – Maintenance end point identifier. (Range: 1-8191)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
EXAMPLE
This example shows the fault notification settings configured for one MEP.
Console#show ethernet cfm fault-notify-generator mep 1
MD Name MA Name Highest Defect Lowest Alarm Alarm Time Reset Time
------------ ------------ -------------- ------------- ---------- ----------
voip rd none macRemErrXcon 3sec. 10sec.
Console#
Table 185: show fault-notify-generator - display description
Field Description
MD Name The maintenance domain for this entry.
MA Name The maintenance association for this entry.
Hihest Defect The highest defect that will generate a fault alarm. (This is disabled
by default.)
Lowest Alarm The lowest defect that will generate a fault alarm (see the mep fault-
notify lowest-priority command).
Alarm Time The time a defect must exist before a fault alarm is issued (see the
mep fault-notify alarm-time, command).
Reset Time The time after a fault alarm has been issued, and no defect exists,
before another fault alarm can be issued (see the mep fault-notify
reset-time command).
To Next Page
Loading...
