Edge-Core ES3528MV2 - Wtr-Timer

C HAPTER 35 | ERPS Commands
– 1114 –
wtr-timer This command sets the wait-to-restore timer which is used to verify that
the ring has stabilized before blocking the RPL after recovery from a signal
failure. Use the no form to restore the default setting.
SYNTAX
wtr-timer minutes
minutes - The wait-to-restore timer is used to verify that the ring
has stabilized before blocking the RPL after recovery from a signal
failure. (Range: 5-12 minutes)
DEFAULT SETTING
5 minutes
COMMAND MODE
ERPS Configuration
COMMAND USAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
EXAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
clear erps statistics This command clears statistics, including SF, NR, NR-RB, FS, MS, Event,
and Health protocol messages.
SYNTAX
clear erps statistics [domain ring-name]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear erps statistics domain r&d
Console#