C
HAPTER
20
| System Management Commands
Time
– 758 –
â—† This command sets the summer-time time zone relative to the
currently configured time zone. To specify a time corresponding to your
local time when summer time is in effect, you must indicate the number
of minutes your summer-time time zone deviates from your regular
time zone (that is, the offset).
EXAMPLE
The following example sets the 2014 Summer Time ahead by 60 minutes
on March 9th and returns to normal time on November 2nd.
Console(config)#clock summer-time DEST date march 9 2014 01 59 november 2
2014 01 59 60
Console(config)#
clock summertime
(predefined)
This command configures the summer time (daylight savings time) status
and settings for the switch using predefined configurations for several
major regions of the world. Use the no form to disable summer time.
SYNTAX
clock summer-time name predefined [australia | europe |
new-zealand | usa]
no clock summer-time
name - Name of the timezone while summer time is in effect,
usually an acronym. (Range: 1-30 characters)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† In some countries or regions, clocks are adjusted through the summer
months so that afternoons have more daylight and mornings have less.
This is known as Summer Time, or Daylight Savings Time (DST).
Typically, clocks are adjusted forward one hour at the start of spring
and then adjusted backward in autumn.
â—† This command sets the summer-time time relative to the configured
time zone. To specify the time corresponding to your local time when
summer time is in effect, select the predefined summer-time time zone
appropriate for your location, or manually configure summer time if
these predefined configurations do not apply to your location (see clock
summer-time (date) or clock summertime (recurring).
To Next Page
Loading...
Need help?
General
