C
HAPTER
18
| Using the Command Line Interface
Entering Commands
– 685 –
EXEC COMMANDS When you open a new console session on the switch with the user name
and password “guest,” the system enters the Normal Exec command mode
(or guest mode), displaying the “Console>” command prompt. Only a
limited number of the commands are available in this mode. You can
access all commands only from the Privileged Exec command mode (or
administrator mode). To access Privilege Exec mode, open a new console
session with the user name and password “admin.” The system will now
display the “Console#” command prompt. You can also enter Privileged
Exec mode from within Normal Exec mode, by entering the enable
command, followed by the privileged level password “super.”
To enter Privileged Exec mode, enter the following user names and
passwords:
Username: admin
Password: [admin login password]
CLI session with the ES3528MV2 is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the ES3528MV2 is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#
Table 41: General Command Modes
Class Mode
Exec Normal
Privileged
Configuration
Global
*
Access Control List
CFM
Class Map
ERPS
IGMP Profile
Interface
Line
Multiple Spanning Tree
Policy Map
Time Range
VLAN Database
* You must be in Privileged Exec mode to access the Global configuration mode.
You must be in Global Configuration mode to access any of the other configuration
modes.
To Next Page
Loading...
Need help?
General
