C
HAPTER
35
| ERPS Commands
– 1112 –
of the RPL. If the switch is set as the RPL neighbor for an ERPS domain,
the east ring port is set as the other end of the RPL.
â—† The east and west connections to the ring must be specified for all ring
nodes using the ring-port command. When this switch is configured as
the RPL neighbor, the east ring port is set as being connected to the
RPL.
â—† Note that is not mandatory to declare a RPL neighbor.
EXAMPLE
Console(config-erps)#rpl neighbor
Console(config-erps)#
rpl owner This command configures a ring node to be the Ring Protection Link (RPL)
owner. Use the no form to restore the default setting.
SYNTAX
rpl owner
no rpl
DEFAULT SETTING
None (that is, neither owner nor neighbor)
COMMAND MODE
ERPS Configuration
COMMAND USAGE
â—† Only one RPL owner can be configured on a ring. The owner blocks
traffic on the RPL during Idle state, and unblocks it during Protection
state (that is, when a signal fault is detected on the ring or the
protection state is enabled with the erps forced-switch or erps manual-
switch command).
â—† The east and west connections to the ring must be specified for all ring
nodes using the ring-port command. When this switch is configured as
the RPL owner, the west ring port is automatically set as being
connected to the RPL.
EXAMPLE
Console(config-erps)#rpl owner
Console(config-erps)#
To Next Page
Loading...
Need help?
General
