C
HAPTER
35
| ERPS Commands
– 1095 –
7. Enable an ERPS ring: Before an ERPS ring can work, it must be enabled
using the enable command. When configuration is completed and the
ring enabled, R-APS messages will start flowing in the control VLAN,
and normal traffic will begin to flow in the data VLANs. To stop a ring, it
can be disabled on any node using the no enable command.
8. Display ERPS status information: Use the show erps command to
display general ERPS status information or detailed ERPS status
information for a specific ring.
erps This command enables ERPS on the switch. Use the no form to disable this
feature.
SYNTAX
[no] erps
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
ERPS must be enabled globally on the switch before it can enabled on an
ERPS ring using the enable command.
EXAMPLE
Console(config)#erps
Console(config)#
RELATED COMMANDS
enable (1097)
erps domain This command creates an ERPS ring and enters ERPS configuration mode
for the specified domain. Use the no form to delete a ring.
SYNTAX
[no] erps domain ring-name [id ring-id]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages.
(Range: 1-255)
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General
