C
HAPTER
17
| Multicast Filtering
Multicast VLAN Registration for IPv6
– 669 –
ASSIGNING STATIC
MVR6 MULTICAST
GROUPS TO
INTERFACES
Use the Multicast > MVR6 (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI REFERENCES
◆ "mvr6 vlan group" on page 1287
COMMAND USAGE
◆ Multicast groups can be statically assigned to a receiver port using this
configuration page.
◆ All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
◆ The MVR6 VLAN cannot be specified as the receiver VLAN for static
bindings.
PARAMETERS
These parameters are displayed:
◆ Domain ID – An independent multicast domain. (Range: 1-5)
◆ Interface – Port or trunk identifier.
◆ VLAN – VLAN identifier. (Range: 1-4094)
◆ Group IPv6 Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR6 group range
configured on the Configure General page.
WEB INTERFACE
To assign a static MVR6 group to an interface:
1. Click Multicast, MVR6.
2. Select Configure Static Group Member from the Step list.
3. Select Add from the Action list.
4. Select an MVR6 domain.
5. Select a VLAN and interface to receive the multicast stream, and then
enter the multicast group address.
6. Click Apply.
To Next Page
Loading...
Need help?
General
