C
HAPTER
19
| General Commands
– 692 –
EXAMPLE
Console(config)#prompt RD2
RD2(config)#
reload
(Global Configuration)
This command restarts the system at a specified time, after a specified
delay, or at a periodic interval. You can reboot the system immediately, or
you can configure the switch to reset after a specified amount of time. Use
the cancel option to remove a configured setting.
SYNTAX
reload {at hour minute [{month day | day month} [year]] |
in {hour hours | minute minutes | hour hours minute minutes} |
regularity
hour minute [
period
{
daily
|
weekly
day-of-week |
monthly
day}] |
cancel [at | in | regularity]}
reload at - A specified time at which to reload the switch.
hour - The hour at which to reload. (Range: 0-23)
minute - The minute at which to reload. (Range: 0-59)
month - The month at which to reload. (january ... december)
day - The day of the month at which to reload. (Range: 1-31)
year - The year at which to reload. (Range: 1970-2037)
reload in - An interval after which to reload the switch.
hours - The number of hours, combined with the minutes,
before the switch resets. (Range: 0-576)
minutes - The number of minutes, combined with the hours,
before the switch resets. (Range: 0-59)
reload
regularity
- A periodic interval at which to reload the
switch.
hour - The hour at which to reload. (Range: 0-23)
minute - The minute at which to reload. (Range: 0-59)
day-of-week - Day of the week at which to reload.
(Range: monday ... saturday)
day
- Day of the month at which to reload. (Range: 1-31)
reload cancel - Cancels the specified reload option.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
To Next Page
Loading...
