C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv4
– 1270 –
clear mrv statistics This command clears MRV statistics.
SYNTAX
clear mrv statistics [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-12)
vlan vlan-id - VLAN identifier (Range: 1-4094)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear ip igmp snooping statistics
Console#
show mvr This command shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current number of group
addresses, and the upstream source IP address.
SYNTAX
show mvr [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Displays configuration settings for all MVR domains.
COMMAND MODE
Privileged Exec
EXAMPLE
The following shows the MVR settings:
Console#show mvr
MVR 802.1p Forwarding Priority : Disabled
MVR Proxy Switching : Enabled
MVR Robustness Value : 1
MVR Proxy Query Interval : 125(sec.)
MVR Source Port Mode : Always Forward
MVR Domain : 1
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
To Next Page
Loading...
Need help?
General
