Edge-Core ES3528MV2 - Accounting Dot1 X

C HAPTER 24 | Authentication Commands
AAA
– 830 –
EXAMPLE
Console(config)#aaa group server radius tps
Console(config-sg-radius)#server 10.2.68.120
Console(config-sg-radius)#
accounting dot1x This command applies an accounting method for 802.1X service requests
on an interface. Use the no form to disable accounting on the interface.
SYNTAX
accounting dot1x {default | list-name}
no accounting dot1x
default - Specifies the default method list created with the aaa
accounting dot1x command.
list-name - Specifies a method list created with the aaa accounting
dot1x command.
DEFAULT SETTING
None
COMMAND MODE
Interface Configuration
EXAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#accounting dot1x tps
Console(config-if)#
accounting
commands
This command applies an accounting method to entered CLI commands.
Use the no form to disable accounting for entered CLI commands.
SYNTAX
accounting commands level {default | list-name}
no accounting commands level
level - The privilege level for executing commands. (Range: 0-15)
default - Specifies the default method list created with the aaa
accounting commands command.
list-name - Specifies a method list created with the aaa accounting
commands command.
DEFAULT SETTING
None