C
HAPTER
41
| CFM Commands
Continuity Check Operations
– 1342 –
mep
archive-hold-time
This command sets the time that data from a missing MEP is retained in
the continuity check message (CCM) database before being purged. Use
the no form to restore the default setting.
SYNTAX
mep archive-hold-time hold-time
hold-time – The time to retain data for a missing MEP.
(Range: 1-65535 minutes)
DEFAULT SETTING
100 minutes
COMMAND MODE
CFM Domain Configuration
COMMAND USAGE
A change to the hold time only applies to entries stored in the database
after this command is entered.
EXAMPLE
This example sets the aging time for missing MEPs in the CCM database to
30 minutes.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep archive-hold-time 30
Console(config-ether-cfm)#
clear ethernet cfm
maintenance-points
remote
This command clears the contents of the continuity check database.
SYNTAX
clear ethernet cfm maintenance-points remote
[domain domain-name | level level-id]
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
level-id – Maintenance level. (Range: 0-7)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
Use this command without any keywords to clear all entries in the CCM
database. Use the domain keyword to clear the CCM database for a
specific domain, or the level keyword to clear it for a specific maintenance
level.
To Next Page
Loading...
Need help?
General
