C
HAPTER
30
| Congestion Control Commands
Automatic Traffic Control Commands
– 1035 –
seconds - The time at which to release the control response after
ingress traffic has fallen beneath the lower threshold.
(Range: 1-900 seconds)
DEFAULT SETTING
900 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the delay after which the control response can be
terminated. The auto-traffic-control auto-control-release command must
be used to enable or disable the automatic release of a control response of
rate-limiting. To re-enable a port which has been shut down by automatic
traffic control, you must manually re-enable the port using the auto-traffic-
control control-release command.
EXAMPLE
This example sets the release timer to 800 seconds for all ports.
Console(config)#auto-traffic-control broadcast release-timer 800
Console(config)#
auto-traffic-control This command enables automatic traffic control for broadcast or multicast
storms. Use the no form to disable this feature.
SYNTAX
[no] auto-traffic-control {broadcast | multicast}
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
â—† Automatic storm control can be enabled for either broadcast or
multicast traffic. It cannot be enabled for both of these traffic types at
the same time.
â—† Automatic storm control is a software level control function. Traffic
storms can also be controlled at the hardware level using the
switchport packet-rate command. However, only one of these control
types can be applied to a port. Enabling automatic storm control on a
port will disable hardware-level storm control on that port.
To Next Page
Loading...
Need help?
General
