C
HAPTER
13
| Security Measures
Network Access (MAC Address Authentication)
– 334 –
supported, the guest VLAN to use when MAC Authentication or 802.1X
Authentication fails, and the dynamic VLAN and QoS assignments.
5. Click Apply.
Figure 176: Configuring Interface Settings for Network Access
CONFIGURING PORT
LINK DETECTION
Use the Security > Network Access (Configure Interface - Link Detection)
page to send an SNMP trap and/or shut down a port when a link event
occurs.
CLI REFERENCES
◆ "Network Access (MAC Address Authentication)" on page 879
PARAMETERS
These parameters are displayed:
◆ Link Detection Status – Configures whether Link Detection is enabled
or disabled for a port.
◆ Condition – The link event type which will trigger the port action.
■
Link up – Only link up events will trigger the port action.
■
Link down – Only link down events will trigger the port action.
■
Link up and down – All link up and link down events will trigger
the port action.
◆ Action – The switch can respond in three ways to a link up or down
trigger event.
■
Trap – An SNMP trap is sent.
■
Trap and shutdown – An SNMP trap is sent and the port is shut
down.
■
Shutdown – The port is shut down.
To Next Page
Loading...
