C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv6
– 1278 –
mvr6
associated-profile
This command binds the MVR group addresses specified in a profile to an
MVR domain. Use the no form of this command to remove the binding.
SYNTAX
[no] mvr6 domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
MRV6 domains can be associated with more than one MVR6 profile. But
since MVR6 domains cannot share the group range, an MRV6 profile can
only be associated with one MVR6 domain.
EXAMPLE
The following an MVR group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
clear mvr6 statistics Clears the MVR statistics globally or on a per-interface
basis.
PE
show mvr6 Shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current
number of group addresses, and the upstream source IP
address
PE
show mvr6
associated-profile
Shows the profiles bound the specified domain PE
show mvr6 interface Shows MVR settings for interfaces attached to the MVR
VLAN
PE
show mvr6 members Shows information about the current number of entries
in the forwarding database, or detailed information about
a specific multicast address
PE
show mvr6 profile Shows all configured MVR profiles PE
show mvr6 statistics Shows MVR protocol statistics for the specified interface PE
Table 169: Multicast VLAN Registration for IPv6 Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
