Edge-Core ES3528MV2 - Show Interfaces Status

C HAPTER 27 | Interface Commands
Interface Configuration
– 987 –
===== Port Utilization =====
111 Octets Input in kbits per second
0 Packets Input per second
0.00 % Input Utilization
606 Octets Output in kbits per second
1 Packets Output per second
0.00 % Output Utilization
Console#
show interfaces
status
This command displays the status for an interface.
SYNTAX
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4094)
DEFAULT SETTING
Shows the status for all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed. For a
description of the items displayed by this command, see "Displaying
Connection Status" on page 153.
EXAMPLE
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 100BASE-TX
MAC Address : 70-72-CF-58-FE-B6
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 64 kbits/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled