C
HAPTER
13
| Security Measures
Access Control Lists
– 368 –
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI REFERENCES
â—† "ip access-group" on page 956
â—† "show ip access-group" on page 957
â—† "mac access-group" on page 968
â—† "show mac access-group" on page 969
â—† "Time Range" on page 762
PARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier.
◆ ACL – ACL used for ingress or egress packets.
◆ Time Range – Name of a time range.
◆ Counter – Enables counter for ACL statistics.
WEB INTERFACE
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select IP, MAC or IPv6 from the Type list.
4. Select a port.
5. Select the name of an ACL from the ACL list.
6. Click Apply.
To Next Page
Loading...
Need help?
General
