C
HAPTER
20
| System Management Commands
Line
– 731 –
COMMAND USAGE
â—† If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
â—† This command applies to both the local console and Telnet connections.
â—† The timeout for Telnet cannot be disabled.
â—† Using the command without specifying a timeout restores the default
setting.
EXAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#
login This command enables password checking at login. Use the no form to
disable password checking and allow connections without a password.
SYNTAX
login [local]
no login
local - Selects local password checking. Authentication is based on
the user name specified with the username command.
DEFAULT SETTING
login local
COMMAND MODE
Line Configuration
COMMAND USAGE
â—† There are three authentication modes provided by the switch itself at
login:
â–
login selects authentication by a single global password as
specified by the password line configuration command. When using
this method, the management interface starts in Normal Exec (NE)
mode.
â–
login local selects authentication via the user name and password
specified by the username command (i.e., default setting). When
using this method, the management interface starts in Normal Exec
(NE) or Privileged Exec (PE) mode, depending on the user’s
privilege level (0 or 15 respectively).
â–
no login selects no authentication. When using this method, the
management interface starts in Normal Exec (NE) mode.
To Next Page
Loading...
Need help?
General
